Quantcast
Channel: Motorcycles Repair Manual Download and Reviews » Search Results » adjust brake pedal on 2003 harley road king
Viewing all articles
Browse latest Browse all 10

HARLEY DAVIDSON IRONSIDE BRAKE PEDAL PAD INSTALLATION INSTRUCTIONS

0
0

download
INSTALLATION 1. Remove the previously installed brake pedal cover from the foot brake lever. 2. See Figure 1. Obtain the mounting plate (7) from kit. Position the mounting plate over the brake pedal (A) aligning raised area under plate with oval hole in brake pedal. 3. Obtain the offset washer (2) from kit. Position washer under brake pedal and align the “offset” area of the washer so that it covers oval hole in brake pedal. 4. From top of mounting plate, install 5/16 inch flathead screw (1) through mounting plate (7), brake pedal (A) and offset washer (2). 5. From under brake pedal, install acorn nut (3) to secure mounting plate and offset washer to brake pedal. Tighten acorn nut to 25-29 ft-lbs (33-39 Nm). 6. Obtain brake pedal cover (5) and pedal tread (6) from kit. Align and insert tread (6) into the brake pedal cover. 7. From the side, slide the brake pedal cover assembly over the mounting plate (and pedal) and align the two holes in bottom of cover with two holes in mounting plate. 8. Obtain the two 10-24 screws (4) from kit. From under brake pedal (A), install screws through holes in mounting plate (7) and into pedal cover (5). Tighten screws to 20-22 in- lbs (2.2-2.5 Nm)

Incoming search terms:


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images